中文

Journal of Shanghai University >

2018 , Vol. 24 >Issue 2: 272 - 277

DOI: https://doi.org/10.12066/j.issn.1007-2861.1823

Research Articles

Influence of molding process parameters on compressive strength for polyimide resin and establishment of mathematical model

Expand
  • 1. Research Center for Composite Materials, Shanghai University, Shanghai 200072, China
    2. Dnepropetrovsk State Agraian University, Dnepropetrovsk 49027, Ukraine

Received date: 2016-05-16

  Online published: 2018-05-07

Fold

Abstract

Influence of molding temperature and duration time on the strength of polyimide were investigated, and a mathematical model was established. The results indicate that the pressing parameters have significant effects on the strength of polyimide. The compressive strength reaches maximum when the molding temperature is 653 K and non-pressure duration time is 25 min. Besides, a fitted quadric multiple equation is obtained with orthogonal central composite design. It can fully characterize compressive strength of polyimide within the research domain.

Key words： polymers; molding; pressing; process parameters; temperature; duration time; mathematical model

Cite this article

FANG Lin, BURYA A I, YU Mingming, REN Musu, KALINICHENKO C B, EREMINA E A . Influence of molding process parameters on compressive strength for polyimide resin and establishment of mathematical model[J]. Journal of Shanghai University, 2018 , 24(2) : 272 -277 . DOI: 10.12066/j.issn.1007-2861.1823

References

[1] Le T H, Yang Y. Polyimide-based porous hollow carbon nanofibers for supercapacitorelectrode[J]. Journal of Applied Polymer Science, 2016, DOI: 10.1002/app.43397.
[2] Freddy Y C, Boey X L. Modeling the curing kinetics for a modified bismaleimide resin[J]. Journal of Polymer Science Part A: Polymer Chemistry, 2000,38:907-913.
[3] 周洪飞. 聚酰亚胺树脂固化动力学参数研究[J]. 热固性树脂, 2005,20(4):11-13.
[4] 刘志真. RTM 聚酰亚胺复合材料力学性能研究[J]. 材料工程, 2007(1):98-101.
[5] Ye X Y, Liu X H. Tribological properties of fluorinated graphene reinforced polyimide composite coatings under different lubricated conditions[J]. Composites Part A: Applied Science and Manufacturing, 2016,81:282-288.
[6] 陈建升, 左红军, 杨海霞, 等. 适用于 RTM 成型聚酰亚胺树脂的合成与性能研究[J]. 航空材料学报, 2006,26(3):183-186.
[7] Xu X C, Yuan Z J. The molding study of polyimide polishing film[J]. Key Engineering Materials, 2008,375:288-292.
Options
Outlines

/

〈 〉