一种改进的异步电机模型预测直接转矩控制方法

宋文祥, 乐胜康, 吴晓新, 阮毅

doi:10.12066/j.issn.1007-2861.1890

上海大学学报(自然科学版) >

2018 , Vol. 24 >Issue 6: 861 - 876

DOI: https://doi.org/10.12066/j.issn.1007-2861.1890

研究论文

一种改进的异步电机模型预测直接转矩控制方法

展开

上海大学机电工程与自动化学院, 上海 200444

收稿日期: 2017-01-21

网络出版日期: 2018-12-24

基金资助

国家自然科学基金资助项目(51377102);国家重大科学仪器设备开发专项资助项目(2012YQ15008703)

收起

Improved model predictive direct torque control for asynchronous machine

Expand

School of Mechatronic Engineering and Automation, Shanghai University, Shanghai 200444, China

Received date: 2017-01-21

Online published: 2018-12-24

Fold

摘要

提出一种改进的模型预测直接转矩控制方法,通过磁链和转矩方程设计出一种优化矢量选择器,能够根据转矩和定子磁链的给定值得到给定的电压矢量.该方法只需对给定电压矢量所在扇区的 3 个电压矢量进行价值函数评估,使得在线优化计算量得到有效降低.针对由控制延时导致的定子电流在参考值附近振荡并增加电流纹波和转矩脉动,采用延时补偿提高了控制系统的性能.通过在模型预测直接转矩控制的价值函数中加入开关切换次数约束,能够在兼顾转矩和磁链偏差的同时进一步降低逆变器开关频率. 最后,通过仿真和实验验证了所提出方法的有效性和可行性.

关键词： 异步电机; 直接转矩控制; 延时补偿; 模型预测控制; 低开关频率

本文引用格式

宋文祥, 乐胜康, 吴晓新, 阮毅 . 一种改进的异步电机模型预测直接转矩控制方法[J]. 上海大学学报(自然科学版), 2018 , 24(6) : 861 -876 . DOI: 10.12066/j.issn.1007-2861.1890

Abstract

This paper proposes an improved model predictive direct torque control (MPDTC) method. An optimal voltage vector selector is obtained by analyzing relationship between stator flux and torque, which can be used to calculate the desired voltage vector based on the stator flux and torque reference. The method only needs to evaluate three voltage vectors in a sector of the desired voltage vector. As a result, the computational burden of conventional MPDTC is reduced effectively. Time delay introduced in computation can cause the stator current to oscillate around its reference and increase current and torque ripples. To solve the problem, a delay compensation method is used. Furthermore, switching frequency of the inverter is reduced significantly by introducing a constraint of power semiconductors switching number to the cost function of MPDTC. Both simulation and experimental results are presented to verify validity and feasibility of the proposed method.

Key words： asynchronous machine; direct torque control; delay compensation; model predictive control; low switching frequency

参考文献

[1]	Datta R, Ranganathan V T. A simple position-sensorless algorithm for rotor-side field-oriented control of wound-rotor induction machine[J]. IEEE Transactions on Industrial Electronics, 2001,48(4):786-793.
[2]	Takahashi I, Noguchi T. A new quick-response and high-efficiency control strategy of an induction motor[J]. IEEE Transactions on Industry Applications, 1986,22(5):820-827.
[3]	Lascu C, Boldea I, Blaabjerg F. A modified direct torque control for induction motor sensorless drive[J]. IEEE Transactions on Industry Applications, 2000,36(1):122-130.
[4]	Casadei D, Profumo F, Serra G, et al. FOC and DTC: two viable schemes for induction motors torque control[J]. IEEE Transactions on Power Electronics, 2002,17(5):779-787.
[5]	Sorchini Z, Krein P T. Formal derivation of direct torque control for induction machines[J]. IEEE Transactions on Power Electronics, 2006,21(5):1428-1436.
[6]	Idris N R N, Toh C L, Elbuluk M E. A new torque and flux controller for direct torque control of induction machines[J]. IEEE Transactions on Industry Applications, 2006,42(6):1358-1366.
[7]	廖永衡, 冯晓云, 王珍. 基于定子磁链滑模观测器的异步电机空间矢量调制直接转矩控制[J]. 中国电机工程学报, 2012,32(18):88-97.
[8]	张华强, 王新生, 魏鹏飞, 等. 基于空间矢量调制的直接转矩控制算法研究[J]. 电机与控制学报, 2012,16(6):13-18.
[9]	Kouro S, Cortés P, Vargas R, et al. Model predictive control: a simple and powerful method to control power converters[J]. IEEE Transactions on Industrial Electronics, 2009,56(6):1826-1838.
[10]	Tarisciotti L, Calzo G L, Gaeta A, et al. A distributed model predictive control strategy for back-to-back converters[J]. IEEE Transactions on Industrial Electronics, 2016,63(9):5867-5878.
[11]	Rodriguez J, Kennel R M, Espinoza J R, et al. High-performance control strategies for electrical drives: an experimental assessment[J]. IEEE Transactions on Industrial Electronics, 2012,59(2):812-820.
[12]	Holtz J, Stadtfeld S. A predictive controller for the stator current vector of AC-machines fed from a switched voltage source [C]// IEEE International Power Electronics Conference. 1983: 1665-1675.
[13]	宋文祥, 阮智勇, 朱洪志, 等. 异步电机低开关频率的模型预测直接电流控制[J]. 上海大学学报 (自然科学版), 2013,19(6):647-653.
[14]	Xie W, Wang X, Wang F, et al. Finite control set-model predictive torque control with a deadbeat solution for PMSM drives[J]. IEEE Transactions on Industrial Electronics, 2015,62(9):5402-5410.
[15]	Kwak S, Park J C. Switching strategy based on model predictive control of VSI to obtain high efficiency and balanced loss distribution[J]. IEEE Transactions on Power Electronics, 2014,29(9):4551-4567.
[16]	Villarroel F, Espinoza J R, Rojas C A, et al. Multiobjective switching state selector for finite-states model predictive control based on fuzzy decision making in a matrix converter[J]. IEEE Transactions on Industrial Electronics, 2013,60(2):589-599.
[17]	Lim C S, Rahim N A, Hew W P, et al. Model predictive control of a two-motor drive with five-leg-inverter supply[J]. IEEE Transactions on Industrial Electronics, 2013,60(1):54-65.
[18]	Rodriguez J, Pontt J, Silva C A, et al. Predictive current control of a voltage source inverter[J]. IEEE Transactions on Industrial Electronics, 2007,54(1):495-503.
[19]	Karamanakos P, Stolze P, Kennel R, et al. Variable switching point predictive torque control [C]// IEEE International Conference on Industrial Technology. 2013: 422-427.
[20]	Zhang Y, Zhu J, Zhao Z, et al. An improved direct torque control for three-level inverter-fed induction motor sensorless drive[J]. IEEE Transactions on Power Electronics, 2012,27(3):1502-1513.
[21]	Cortes P, Rodriguez J, Silva C, et al. Delay compensation in model predictive current control of a three-phase inverter[J]. IEEE Transactions on Industrial Electronics, 2012,59(2):1323-1325.

Options

文章导航

模态框（Modal）标题

摘要

本文引用格式

Abstract

参考文献