研究论文

表层嵌贴CFRP 板加固RC 梁的抗弯性能

展开
  • 上海大学土木工程系, 上海 200444
张智梅(1972—), 女, 副教授, 博士, 研究方向为混凝土结构加固. E-mail: zhangzhimei@staff.shu.edu.cn

收稿日期: 2015-04-03

  网络出版日期: 2017-04-30

Flexural behavior of RC beams strengthened with near surface mounted CFRP strips

Expand
  • Department of Civil Engineering, Shanghai University, Shanghai 200444, China

Received date: 2015-04-03

  Online published: 2017-04-30

摘要

利用ABAQUS 有限元软件对表层嵌贴碳纤维增强复合材料(carbon fiber reinforced polymer/plastic, CFRP)板加固钢筋混凝土(reiforced concrete, RC)梁的抗弯性能进行非线性有限元分析. 通过模拟5 根表层嵌贴CFRP 板加固RC 梁, 并将数值模拟结果与试验结果、理论计算结果进行对比, 以此验证所建模型的正确性. 利用验证后的有限元模型深入分析嵌贴长度、开槽数量、加固方式、纵向配筋率对RC 梁抗弯性能的影响. 模拟结果表明: 嵌贴长度和纵向配筋率对RC梁的抗弯性能影响较大; 开槽数量、加固方式对RC梁的抗弯性能影响较小. 另外, 提出了CFRP 板的界限加固量公式.

本文引用格式

张智梅, 张振波, 黄海涛, 张振凯, 熊浩 . 表层嵌贴CFRP 板加固RC 梁的抗弯性能[J]. 上海大学学报(自然科学版), 2017 , 23(2) : 298 -307 . DOI: 10.3969/j.issn.1007-2861.2015.02.002

Abstract

This paper uses the finite element software ABAQUS for nonlinear finite element analysis of the flexural behavior of reinforced concrete (RC) beams with near-surface mounted (NSM) carbon fiber reinforced polymer/plastic (CFRP) strips. Through simulation of 5 beams with NSM CFRP strips from the test, the experimental and theoretical results were compared to verify accuracy of the model. Using the verified finite element model, the influence of factors were analyzed such as FRP length, groove number, reinforcement method and longitudinal reinforcement ratio on the flexural behavior of RC beams. The results show that the CFRP length and longitudinal reinforcement ratio have a larger impact on the flexural behavior of the RC beams, while the impacts of groove number and reinforcement method are limited. This paper also proposes a boundary reinforcement quantity formula for CFRP strips.

参考文献

[1] 李荣, 滕锦光, 岳清瑞. FRP材料加固混凝土结构应用的新领域——嵌入式(NSM)加固法[J]. 工业建筑, 2004, 34(4): 5-10.
[2] 张智梅, 考书姣, 白世烨. CFRP布加固钢筋混凝土梁的抗弯性能研究[J]. 结构工程师, 2012, 28(4): 139-143.
[3] 孙志洋, 张智梅, 刘涛. 内嵌CFRP 板加固已损伤RC 梁抗弯性能的试验研究[J]. 四川建筑科学研究, 2013, 39(4): 112-116.
[4] 贺学军, 周朝阳, 徐玲. 内嵌CFRP 板条加固混凝土梁的抗弯性能试验研究[J]. 土木工程学报, 2008, 41(12): 14-20.
[5] 陆新征, 滕锦光, 叶列平, 等. FRP 加固混凝土梁受弯剥离破坏的有限元分析[J]. 工程力学, 2006, 23(6): 85-93.
[6] 周朝阳, 向传家, 贺学军. 内嵌FRP 加固钢筋混凝土梁的受弯承载力分析[J]. 建筑结构, 2006, 36(12): 19-21.
[7] 梁金福, 燕柳斌, 赵君君, 等. CFRP板条嵌入式加固钢筋混凝土梁抗弯性能试验研究[J]. 工业建筑, 2009, 39(2): 100-102.
[8] 曾宪桃, 成香莉, 高保彬. 内嵌碳纤维增强塑料板条抗弯加固混凝土梁试验研究[J]. 工程力学, 2008, 25(12): 106-113.
[9] De Lorenzis L. Anchorage length of near-surface mounted fiber-reinforced polymer rods for concrete strengthening analytical modeling [J]. ACI Structure Journal, 2004, 101(2): 375-386.
[10] Teng J G, Lorenzis L D, Wang B, et al. Debonding failures of RC beams strengthened with near-surface mounted CFRP strips [J]. Journal of Composites for Construction, 2006, 10(2): 92-105.
[11] De Lorenzis L, Teng J G. Near-surface mounted FRP reinforcement: an emerging technique for strengthening structures [J]. Composites Part B: Engineering, 2007, 38: 119-143.
[12] Novidis D, Pantazopoulou S J, Tentolouris E. Experimental study of bond of NSM-FRP reinforcement [J]. Construction and Building Materials, 2007, 21(8): 1760-1770.

文章导航

/