Please wait a minute...


当期目录

    2002年 第23卷 第4期    刊出日期:2002-04-18
    论文
    ONE-DIMENSIONAL CELLULAR AUTOMATON MODEL OF TRAFFIC FLOW BASED ON CAR-FOLLOWING IDEA
    董力耘;薛郁;戴世强
    2002, 23(4):  363-370. 
    摘要 ( 518 )   PDF (737KB) ( 534 )  
    参考文献 | 相关文章 | 多维度评价
    An improved one-dimensional CA (Cellular Automaton) traffic model was proposed to describe the highway traffic under the periodic boundary conditions. This model was based on the idea of the car-following model, which claims that the motion of a vehicle at one time step depends on both its headway and the synchronous motion of the front vehicle, thus including indirectly the influence of its sub-neighboring vehicle. In addition, the so-called safety distance was introduced to consider the deceleration behavior of vehicles and the stochastic factor was taken into account by introducing the deceleration probability. Meanwhile, the conditional deceleration in the model gives a better description of the phenomena observed on highways. It is found that there exists the metastability and hysteresis effect of traffic flow in the neighborhood of critical density under different initial conditions. Since this model gives a reasonable depiction of the motion of a single vehicle, it is easy to be extended to the case of traffic flow under the control of traffic lights in cities.
    THE INTERACTION PROBLEM BETWEEN THE ELASTIC LINE INCLUSIONS
    陶昉敏;张明焕;汤任基
    2002, 23(4):  371-379. 
    摘要 ( 534 )   PDF (502KB) ( 250 )  
    参考文献 | 相关文章 | 多维度评价
    Using the engineering model of elastic line inclusion and the basic solutions of a single inclusion, the interaction problem between line inclusions in an elastic solid was investigated. A set of standard Cauchy-type singular equations of the problem was presented. The stress intensity factors at points of inclusions and the interface stresses of two sides of the inclusion were calculated. Several numerical examples were given. The results could be regarded as a reference to engineering.
    SIMILARITY REDUCTIONS FOR THE NONLINEAR EVOLUTION EQUATION ARISING IN THE FERMI-PASTA-ULAM PROBLEM
    谢福鼎;闫振亚;张鸿庆
    2002, 23(4):  380-386. 
    摘要 ( 451 )   PDF (458KB) ( 997 )  
    参考文献 | 相关文章 | 多维度评价
    Four families of similarity reductions are obtained for the nonlinear evolution equation arising in the Fermi-Pasta-Ulam problem via using both the direct method due to Clarkson and Kruskal and the improved direct method due to Lou.
    NEW STUDYING OF LATTICE BOLTZMANN METHOD FOR TWO-PHASE DRIVEN IN POROUS MEDIA
    许友生;刘慈群;俞慧丹
    2002, 23(4):  387-393. 
    摘要 ( 490 )   PDF (543KB) ( 350 )  
    参考文献 | 相关文章 | 多维度评价
    By using the interaction of particles,such as the physical principle of the same attract each other and the different repulse each other,a new model of Lattice Boltzmann to simulate the two-phase driven in porous media was discussed. The result shows effectively for the problem of two-phase driven in porous media. Furthermore,the method economizes on computer time, has less fluctuation on boundary surface and takes no average measure.
    SOME CONVERGENCE PROBLEM OF ITERATIVE SEQUENCES FOR ACCRETIVE AND PSEUDO-CONTRACTIVE TYPE MAPPING IN BANACH SPACE
    张石生
    2002, 23(4):  394-408. 
    摘要 ( 523 )   PDF (765KB) ( 459 )  
    参考文献 | 相关文章 | 多维度评价
    Some necessary and sufficient conditions for convergence of Ishikawa Mann and steepest descent iterative sequence for accretive and pseudo-contractive type mapping in Banach spaces were obtained. The results improve, extend and include some recent results.
    KINEMATIC WAVE PROPERTIES OF ANISOTROPIC DYNAMICS MODEL FOR TRAFFIC FLOW
    姜锐;吴清松;朱祚金
    2002, 23(4):  409-414. 
    摘要 ( 492 )   PDF (393KB) ( 334 )  
    参考文献 | 相关文章 | 多维度评价
    The analyses of kinematic wave properties of a new dynamics model for traffic flow are carried out. The model does not exhibit the problem that one characteristic speed is always greater than macroscopic traffic speed, and therefore satisfies the requirement that traffic flow is anisotropic. Linear stability analysis shows that the model is stable under certain condition and the condition is obtained. The analyses also indicate that the model has a hierarchy of first-and second-order waves, and allows the existence of both smooth traveling wave and shock wave. However, the model has a distinctive criterion of shock wave compared with other dynamics models, and the distinction makes the model more realistic in dealing with some traffic problems such as wrong-way travel analysis.
    A MODE Ⅱ CRACK IN A TWO-DIMENSIONAL OCTAGONAL QUASICRYSTALS
    尹姝媛;周旺民;范天佑
    2002, 23(4):  415-420. 
    摘要 ( 559 )   PDF (467KB) ( 266 )  
    参考文献 | 相关文章 | 多维度评价
    The present study develops the fracture theory for a two-dimensional octagonal quasicrystals. The exact analytic solution of a Mode Ⅱ Griffith crack in the material was obtained by using the Fourier transform and dual integral equations theory, then the displacement and stress fields, stress intensity factor and strain energy release rate were determined, the physical sense of the results relative to phason and the difference between mechanical behaviors of the crack problem in crystal and quasicrystal were figured out. These provide important information for studying the deformation and fracture of the new solid phase.
    STATISTIC MODELING OF THE CREEP BEHAVIOR OF METAL MATRIX COMPOSITES BASED ON FINITE ELEMENT ANALYSIS
    岳珠峰
    2002, 23(4):  421-434. 
    摘要 ( 533 )   PDF (944KB) ( 349 )  
    参考文献 | 相关文章 | 多维度评价
    The aim of the paper is to discover the general creep mechanisms for the short fiber reinforcement matrix composites (MMCs) under uniaxial stress states and to build a relationship between the macroscopic steady creep behavior and the material micro geometric parameters. The unit cell models were used to calculate the macroscopic creep behavior with different micro geometric parameters of fibers on different loading directions. The influence of the geometric parameters of the fibers and loading directions on the macroscopic creep behavior had been obtained, and described quantitatively. The matrix/fiber interface had been considered by a third layer, matrix/fiber interlayer, in the unit cells with different creep properties and thickness. Based on the numerical results of the unit cell models, a statistic model had been presented for the plane randomly-distributed-fiber MMCs. The fiber breakage had been taken into account in the statistic model for it starts experimentally early in the creep life. With the distribution of the geometric parameters of the fibers, the results of the statistic model agree well with the experiments. With the statistic model, the influence of the geometric parameters and the breakage of the fibers as well as the properties and thickness of the interlayer on the macroscopic steady creep rate have been discussed.
    NEW HIGH-ORDER MULTI-JOINT FINITE ELEMENT FOR THIN-WALLED BAR
    李正良;白绍良;谢炜
    2002, 23(4):  435-445. 
    摘要 ( 560 )   PDF (530KB) ( 347 )  
    参考文献 | 相关文章 | 多维度评价
    A new high-order multi-joint finite element for thin-walled bar was derived from the Hermite interpolation polynomial and minimum potential energy principle. This element’s characteristics are that it is of high accuracy and can be used in finite method analysis of bridge, tall mega-structure building.
    ELASTIC ANALYSIS OF ORTHOTROPIC PLANE PROBLEMS BY THE SPLINE FICTITIOUS BOUNDARY ELEMENT METHOD
    苏成;韩大建
    2002, 23(4):  446-453. 
    摘要 ( 568 )   PDF (596KB) ( 354 )  
    参考文献 | 相关文章 | 多维度评价
    Non-singular fictitious boundary integral equations for orthotropic elastic plane problems were deduced according to boundary conditions by the techniques of singular-points-outside-domain. Then the unknown fictitious load functions along the fictitious boundary were expressed in terms of basic spline functions, and the boundary-segment-least-squares method was proposed to eliminate the boundary residues obtained. By the above steps, numerical solutions to the integral equations can be achieved. Numerical examples are given to show the accuracy and efficiency of the proposed method.
    ON SOME PROPERTIES OF LIENARD SYSTEMS
    韩茂安
    2002, 23(4):  454-462. 
    摘要 ( 393 )   PDF (455KB) ( 383 )  
    参考文献 | 相关文章 | 多维度评价
    Some sharp sufficient conditions for generalized Lienard systems to have positive or negative semi-orbits which do not cross the vertical isocline are given. Applications of the main results to some polynomial systems are also presented.
    ANALYTICAL SOLUTION OF RADIATION SOUND PRESSURE OF DOUBLE CYLINDRICAL SHELLS IN FLUID MEDIUM
    陈美霞;骆东平;陈小宁;沈瑞喜
    2002, 23(4):  463-470. 
    摘要 ( 481 )   PDF (488KB) ( 537 )  
    参考文献 | 相关文章 | 多维度评价
    The Donnell theory of shell was applied to describe shell motion. The inner and outer shells were stiffened by transverse components. Using deformation harmonious conditions of the interface, the effects of stiffeners were treated as reverse forces and moments on the double cylindrical shell. In the acoustic field produced by vibration and sound radiation of the double shell, the structure dynamic equation, Helmholtz equation in the fluid field and the continuity conditions of the surface of fluid-structure compose the vibration equation coupled by the sound-fluid-structure. The extract of acoustic pressure comes down to the extract of coupling vibration equation. The near field acoustic pressure can be solved directly by complicated calculational methods.
    ON THE CONTINUITY AND DIFFERENTIABILITY OF A KIND OF FRACTAL INTERPOLATION FUNCTION
    李红达;叶正麟;高行山
    2002, 23(4):  471-478. 
    摘要 ( 488 )   PDF (434KB) ( 399 )  
    参考文献 | 相关文章 | 多维度评价
    The sufficient conditions of H*ilder continuity of two kinds of fractal interpolation functions defined by IFS (Iterated Function System) were obtained. The sufficient and necessary condition for its differentiability was proved. Its derivative was a fractal interpolation function generated by the associated IFS, if it is differentiable.
    A COMPUTATIONAL METHOD FOR THE NAVIER-STOKES EQUATIONS AT ALL SPEEDS
    赵兴艳;苏莫明;苗永淼
    2002, 23(4):  479-486. 
    摘要 ( 557 )   PDF (506KB) ( 306 )  
    参考文献 | 相关文章 | 多维度评价
    A PLU-SGS method based on a time-derivative preconditioning algorithm and LU-SGS method is developed in order to calculate the Navier-Stokes equations at all speeds. The equations were discretized using AUSMPW scheme in conjunction with the third-order MUSCL scheme with Van Leer limiter. The present method was applied to solve the multidimensional compressible Navier-Stokes equations in curvilinear coordinates. Characteristic boundary conditions based on the eigensystem of the preconditioned equations were employed. In order to examine the performance of present method, driven-cavity flow at various Reynolds numbers and viscous flow through a convergent-divergent nozzle at supersonic were selected to test this method. The computed results were compared with the experimental data or the other numerical results available in literature and good agreements between them are obtained. The results show that the present method is accurate, self-adaptive and stable for a wide range of flow conditions from low speed to supersonic flows.
[an error occurred while processing this directive]
APS Journals | CSTAM Journals | AMS Journals | EMS Journals | ASME Journals